When I start off, most (if not all) of the lines are dimensioned and constraint properly, but as I work with it, I lose some of them. I'm also aware that a lot of it is due to me not knowing how to create them. Been there, done that.Īs for missing dimensions and what not, yes I'm aware of that. I also don't need the chamfer on the bottom against the glass, I have my printer fine tuned to where I don't need to do that (anymore.) And the hook needs to be 100% filled, otherwise it will break. I already created this part in SketchUp (and printed it), I'm just using it as a learning piece to learn Inventor (while also transitioning all my designs to Inventor.) I will be adjusting that spacing in a bit here so it's actually snug (at 0.1mm) - 0.45 is actually way too much. Mcgyvr, in reality I only need a 0.1mm gap between the parts. I can rotate the way I want it to rotate, so that's good. Ok, figured it out with what Michael did on the file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |